Cyclescheme How to: Cycle on multi-lane roads

Cyclescheme, 25.08.2015

Cyclescheme How to: Cycle on multi-lane roads

Extra lanes can be daunting, whether they're at junctions, on busy urban streets, or dual carriageways. Here's how to take control.

When roads are wide enough to divide into two or more traffic streams, road position and communication are key. There's a certain amount of jostling for position among other road users, especially among those not familiar with the road. You can have traffic on your inside, possibly moving faster than you. And you sometimes have to change lanes yourself. It's easy to be intimidated. But once you're clear about what you're doing, you can cycle smoothly and confidently through the apparent chaos.

Which lane?

You almost always want to be in the left-most lane that goes in the direction that you want to go. So if you're going straight on and you approach a junction with a left-turn-only left-hand lane and a straight-on-or-right right-hand lane, you want to be in the right-hand lane. If both the left-hand lane and right-hand lane have straight-on arrows, you'll want to be in the left hand lane.

'In the lane' will often mean 'in the middle of that lane'. You take the lane. That way you won't be trapped between streams of traffic. You'll be able to control your trajectory through the junction. You'll be more visible to drivers. You'll dissuade them from overtaking when there isn't room for them to do so safely. On a multi-lane road there's another lane for drivers to move into to overtake you, so it's not like you'll be holding them up.

On busy roads with traffic that's moving much faster than you, a position further to the left – perhaps a metre from the left-hand edge – is generally more prudent than taking the centre of the lane. This is especially true when the lane is so wide you can be safely overtaken within it, or when the road as a whole is wide enough for two traffic streams to pass you – for example, a typical dual carriageway.

No lane markings

Some roads are wide enough for side-by-side traffic but are not demarcated by white lines. This is very common at T-junctions, where a single lane widens enough to permit left and right-turning traffic. If it's clear where the de facto lanes are, treat them like marked lanes: get into the leftmost lane that goes were you want to go and, unless there are good reasons not to, take that lane.

Sometimes it's unclear. You get a stretch of one-way road that is wide enough for two streams of traffic but the lines of vehicles overlap, merge and diverge as drivers decide where they want to go. In this situation, the centre of the road is the most confused area. Avoid it! Instead, ride a good distance - a metre or more - out from the side of the road. That way you won't be hemmed in but traffic will be able to pass you easily. Usually you'll be on the left-hand side, but you may have to move across to the right-hand side to get where you want to go. Traffic will then pass on your inside, but this is better than traffic passing on both sides or you being trapped on the wrong side of the road.

Changing lanes

If there's no traffic there's no problem: just go to whichever lane you want to be in. Otherwise, break it down so that you're changing one lane at a time. Look back, signal, eyeball the driver behind to check you can move out, and move towards the right of the lane you're in. Then hold your position. When there's a gap or a courteous driver gives you a gap, move over into the next lane. Repeat as necessary. 

If the road is diverging into two and you want to get into the right-hand lane from the left-hand lane, give yourself enough time to get into position. Don't hug the white lines. Even if the traffic is moving too fast for you to take the lane, it's important that you are clearly visible and that traffic doesn't cut you up. If you can't get across in time, don't take chances: pull over to the left of the left-hand road, stop, wait for a gap in traffic, and walk across to the road you want to be on.

Converging roads, where you have a road coming in from the left, are complicated by the fact that the traffic in the incoming lane may be moving faster than you. Look back and left, signal left, eyeball approaching drivers, and move over into the left-hand lane when there's a gap. If you can't move over as the roads converge, aim to stop and wait within the safety of the 'spearpoint' of solid white lines that traffic will not merge through. Don't continue riding or you'll have fast moving, possibly lane-changing traffic on both sides.

Dual carriageways

Dual carriageways aren't the most pleasant places to cycle but can't always be avoided. Normally you'll be in the secondary position, perhaps a metre out from the left-hand edge of the left-hand lane. The main risk is where slip roads join the dual carriageway. Don't continue along the dual carriageway when you spot an entry slip road. Instead, cross directly over onto the slip road as soon as possible, pausing within the relative safety of the solid-white-line-demarcated 'spearpoint' if you need to wait for a gap in slip road traffic. Then continue along the slip road until it joins the carriageway.

Exit slip roads aren't as risky, but can be negotiated in a similar way. Instead of continuing along the main carriageway, follow the slip road, then cross directly over it where the roads finally diverge to re-join the main carriageway.

Keep up-to-date with our latest content and competitions by...

Liking us on Facebook  

 Following us on Twitter


More articles

How to dry out your damp cycling kit

How to dry out your damp cycling kit

Pulling on cold, soggy lycra and wet shoes for the ride home is grim. Here’s what you can do to avoid the situation.

How to: Know how often you should pump up your tyres

How to: Know how often you should pump up your tyres

Tyres that are too soft spoil the way a bike rides and make punctures likely. Pumping them up now and again is an essential job.

How to: Adjust your bike, not your clothing

How to: Adjust your bike, not your clothing

You don’t need to look like a racer for the journey to work. Normal clothing is fine – as long as your bike is properly equipped.